Flood Risk Due Diligence: A Guide for Buyers, Owners and Advisers
Updated: Nov 9

Would floodwater stop at the back lawn, reach the living room or cut off the only road out? For a buyer looking at a blue patch on a council flood map, those are three very different prospects.
The 2023 Auckland Anniversary Weekend floods and Cyclone Gabrielle generated about $1.8 billion in house insurance claims alone (ICNZ, 2025). For many of the Auckland properties affected there was no river in sight. Sometimes the route is along the driveway, carrying stormwater runoff from the street straight to the garage door.
The clues are spread across the LIM, council maps, property records and the recollections of people who were there. This guide shows how to put that evidence together, what to ask the council and your insurer, and when a survey or engineering assessment could change your decision before you sign.
One property, three different outcomes
Suppose the modelled water level at a house is 10.20 m and at the road low point is 9.70 m. A survey gives the following elevations, all on the same vertical datum (fig.2). The numbers are illustrative.

Surveyed feature | Comparison in this event | Why it matters |
Living floor at 10.55 m | 350 mm above the modelled water at the house | The living floor has clearance in this scenario. Check lower openings, services and uncertainty in the flood level. |
Garage threshold at 10.10 m | 100 mm below the modelled water at the house | Water could enter through the garage. Check whether it can pass from there into the dwelling. |
Access road at 9.70 m | 500 mm below the modelled water at the road | Access may be lost while the living floor stays dry. The depth calculation alone cannot establish safe passage. |

What the buyer did next
In this illustrative example, the living floor clears the modelled water level by 350 mm, yet the garage and access road are exposed. Three questions would shape the buyer’s next steps.
Could water in the garage reach the dwelling?
Suppose the garage slab is level with its 10.10 m threshold and the internal doorway is 180 mm above it. The doorway would be at 10.28 m, only 80 mm above the modelled water level. That smaller margin warrants a check of model uncertainty, other openings and vulnerable services in the garage.
Could the garage threshold be protected?
A raised driveway crest might redirect runoff, but where would it go? A channel drain needs an outlet that can still discharge during the storm. Before pricing either option, check the levels, the effect on neighbours, the approvals required and what happens if the outlet block
How long would the road stay under?
Dated photographs could show how quickly the road drained in a previous storm. To estimate how long access would be lost in this scenario, ask for modelled water levels over time and check whether a higher alternative route remains usable along its full length.
Before committing, the buyer can take the survey and engineering advice to the insurer and lawyer, obtain written cover terms, and weigh the cost of any works against the flood exposure that would remain.
Some additional considerations
A vehicle moving through floodwater on a road, driveway or adjoining ground can push a small wave towards a building. If the water is already just below a garage threshold or low doorway, the wave can briefly carry water over it.
Shallow water across grass, fast flow past foundations and contaminated water inside a wall each have different consequences. Ask how rapidly the water rises, whether it can scour the ground or enter services, and how long it is likely to remain.
A short urban downpour may leave little warning. Consider who uses the property, whether anyone has limited mobility, and whether there is a safe way out before the route floods. An insurance quote tells you what cover is on offer. It cannot answer these physical questions.
Where to find the evidence
Council flood viewer and regional hazard portal
Search the address, the surrounding streets and the access route. Save the relevant layers, legends, model dates and scenarios. Regional information can add river flooding, stopbank and coastal hazards. Where council coverage is limited, check the Earth Sciences New Zealand national flood maps.
Land information memorandum (LIM)
Read the natural hazard section and follow the links. The LIM summarises information the council holds at the issue date. An empty flood entry leaves local drainage and unrecorded events to check.
Council property file
Look for consented drawings, as-built surveys, drainage plans, flood assessments and repair records. A proposed floor level on a drawing may differ from the level actually built.
Record of title and local plan
Ask your lawyer about hazard notifications, consent notices and drainage easements. If you plan to extend or redevelop, check the applicable hazard rules and floor-level requirements with the council.
Vendor, agent and neighbours
Ask which event they remember, where water went, what it reached and what repairs followed. Request dated photographs or reports where available. A dry house in one storm gives evidence about that event.
Coastal projections
For coastal sites, read the council’s inundation assessment alongside NZ SeaRise projections. Identify the assumed sea level, time horizon and local land movement.
What does a ‘1-in-100-year flood’ mean for a homeowner?
If a particular flood level has a 1% chance of being reached or exceeded each year, the chance of reaching it at least once over a 30-year mortgage is about 26%, or roughly one in four. This calculation assumes the flood risk stays the same over the 30 years, and that a flood occurring in one year does not change the chance of one occurring the next. It could happen in your first year of ownership or in successive years. What matters when reading a map is whether the percentage refers to rainfall, river flow or water level.
What does the percentage refer to?
An annual exceedance probability (AEP) is the chance that a specified threshold will be reached or exceeded in any given year. For rainfall, the threshold is an amount of rain falling at a location over a particular duration. A storm might produce an exceptional hour of rain but a fairly ordinary 24-hour total. For a flood, the threshold might instead be the peak river flow or the height the water reaches at a particular location. When reading a map, check what the percentage describes.
AEP, ARI and return period
You may also see an average recurrence interval (ARI), often called a return period. A 1% AEP is commonly described as a 100-year return period. The word average matters. If a flood reached that level last winter, the property has no guaranteed flood-free period ahead of it.

AEP | Equivalent ARI | Plain Language |
10% | 10 years | A frequent storm event. Most public stormwater pipes are designed around this size. |
4% | 25 years | Sometimes used for minor infrastructure. |
2% | 50 years | The Building Code level for protecting houses from surface water entry. |
1% | 100 years | The standard planning event for flood plains in most New Zealand district plans and flood maps. |
0.5% | 200 years | Used for some critical infrastructure and stopbank design. |

How to read the graph. Start at 30 years on the bottom axis and follow it upwards. The 2% AEP curve sits at about 45%, close to an even chance over the life of a mortgage. Even the 0.5% AEP curve reaches 14%, or about one chance in seven. The curves rise because a longer period gives more opportunities for the threshold to be exceeded. They assume the annual probability stays constant and each year is independent.
What does that mean at the front door? A map based on 1% AEP rainfall does not, by itself, give you the odds of water entering the house. For a buyer, the next question is therefore quite specific:
Where is the water expected to reach, compared with the floor, the lowest doorway and the road I need to use to get home?
What the map means at the address
ⓘ Auckland is the example used here. Other councils may have used different labels, model assumptions and mapping methods. Be sure to open the legend and understand the basis of the map before drawing conclusions from the colour of a section.

Map label | What it tells you |
Inside the 1% AEP floodplain | Part of the land is modelled to flood in the specified event. Ask for the water level at the building and access route. Auckland’s regional floodplain mapping assumes the network is working as intended. |
Outside the mapped floodplain | The modelled extent for that scenario stops short of the property. Check for local depressions, blocked inlets, runoff from adjoining land and larger events. Establish whether modelling covers the area at all. |
Flood prone area | A hollow can store water. Find its lowest point and the elevation where water can spill away. Compare the spill elevation with the lowest opening into the building. The outline alone does not tell you how full the hollow gets in a given storm. |
Overland flow path | The line indicates a likely route along low ground. On site, trace where water enters and leaves, how widely it could spread and whether fences, walls or fill obstruct it. A small, unmapped route can still carry water into a garage. |
Flood sensitive area | In Auckland, where mapped, this identifies land close in elevation to the modelled floodplain. Ask which flood level and margin were used. The margin used to draw the map is distinct from the freeboard required for a new floor. |
Coastal inundation or future climate layer | Identify the event, scenario and date. Check what changes in rainfall or sea level are included, whether tidal backing-up of drains is represented, and whether later earthworks are reflected in the terrain. |
Who to ask and what to request
The most productive question to put to a council is usually specific.
✓ ASK THIS
Can you provide the modelled water level at this house, the datum and the scenario?
Gives the engineer or surveyor something usable.
× NOT THIS
Is this property safe?
Asks for a conclusion that regional mapping alone cannot support.
Council flood or stormwater team
The modelled levels at the house and access, where available. Ask about the model date, climate and blockage assumptions, flow paths and any recorded flooding. Ask the regional hazards team about river levels, stopbank overtopping or breach, and coastal scenarios.
Duty planner and property records team
The applicable flood rules, floor-level or freeboard provisions and implications for the proposed extension or change of use. Obtain relevant consents, drawings and recorded conditions.
Vendor and real estate agent
Known flooding, water-entry points, damage, insurance claims, repairs and changes to drains or ground levels. Request records the owner can share. Neighbours may be able to identify which road went under first.
Surveyor
Levels of the finished floor, garage threshold, lowest openings, driveway, boundary spill point and relevant ground, tied to the same datum as the flood model. Agree the survey scope with the engineer first.
Flood or stormwater engineer
An interpretation of the model and site evidence, likely depths and routes, key uncertainties and options. Ask whether existing information and a level survey can resolve the issue before commissioning more detailed modelling.
Insurer or broker and lender
Written flood cover terms for the address, any evidence needed for a firm quote, and confirmation that the lender accepts the available cover. Share material findings before committing.
Property lawyer or conveyancer
The meaning of title notices, easements, LIM entries and sale conditions. Agree what must be resolved and by what date, including before bidding at auction.
When a site assessment is worth commissioning
A mapped fringe across the rear lawn might be resolved by an existing flood level and reliable survey. Seek a site-specific opinion if the water level is close to an opening, the only access route floods, the site has flooded despite a clear map, substantial earthworks postdate the model, or proposed works could redirect flow. Ask the engineer to say which missing fact could change the conclusion and what it would take to establish it.
Before committing to the purchase
Start with the low-cost checks. Bring the insurer and lawyer in early enough to act before the due diligence deadline, or before bidding at an unconditional auction.
✔ Read the public records. Save the council and regional maps and their scenarios. Review the LIM, property file, title notices and easements. At the coast or behind a stopbank, check what the mapping assumes about future water levels or failure of a protection scheme.
✔ Walk the site in safe conditions. Trace the route from uphill land to the boundary, past the building and out again. Identify the lowest opening to the garage or dwelling and the lowest point on the access route. Check whether new fences, retaining walls or fill have changed the route.
✔ Ask for the event history. Where did water come from, how high did it get, what flooded first and how long did it stay? For a previously flooded house, ask for photographs, the repair scope, moisture readings, consent or exemption records and the completed-work documentation. Ask whether water entered steadily or in short surges as vehicles passed.
✔ Resolve the material gaps. Compare actual levels with the modelled water level on a common datum. Where the margin is small, access is uncertain or observations conflict with mapping, obtain a targeted flood assessment. If protection depends on a drain or easement on another property, establish who can maintain it.
✔ Confirm the terms and decide. Give relevant findings to the insurer, lender and lawyer. Establish what is covered, what risk you would carry, and whether any proposed mitigation is feasible, consentable and affordable. If a material question is still open, discuss timing or conditions with your lawyer before committing.
If you already own the property
Reduce the damage
Keep drains and overland routes clear and avoid adding a fence or fill that pushes water towards a neighbour. Store vulnerable items above the likely water level and have a qualified tradesperson assess exposed electrical services. If drainage alterations are proposed, establish where the extra water will go. Keep a dated record of observed flooding, surveys, repairs and mitigation so a future owner can see what changed.
If it floods repeatedly
For a property subject to repeat flooding, ask what level of protection a proposed measure provides, what happens when that level is exceeded, and who will maintain it. A pump or barrier may protect a doorway while leaving access exposed.
If the property floods
For buyers reviewing an earlier flood, the steps below also identify the records worth requesting. A freshly painted room tells you little about how the wall was dried or whether its bracing was reinstated.
Follow emergency directions.
Stay out of floodwater and follow Civil Defence instructions and any building placard. Returning to the neighbourhood does not establish that a particular house is safe. Contact the council if foundations, land or the structure appear damaged or access is restricted.
Contact the insurer and document the event.
When safe, photograph waterlines, contents, outside damage and the route the water took. Keep receipts and agree with the insurer what can be removed or repaired. For qualifying storm or flood damage, Natural Hazards Commission cover is for eligible residential land. Building and contents cover depends on private insurance. The insurer is generally the first contact for both.
Agree the scope before stripping out.
Treat floodwater and silt as contaminated. Have the appropriate professionals check affected services, structural stability and possible asbestos. Establish which linings provide bracing or fire resistance, whether temporary support is needed and which work requires consent or an exemption. A contractor should assess water trapped in cavities or a flooded basement before removal.
Verify drying and repairs.
Ask for moisture readings before walls are closed. MBIE specifies timber framing below 20% moisture content before plasterboard replacement, with some manufacturers requiring a lower value. Record where readings were taken. Obtain the repair details, photographs of concealed fixings and any council records. Drying time depends on the materials, contamination and conditions rather than a fixed number of weeks.
Confirm safe reoccupation and future use.
Resolve council restrictions and confirm that structure, power, water, sanitation and indoor conditions are suitable for occupancy. Review where water entered and whether repairs or feasible changes would reduce repeat damage. If considering raising or relocating the house, assess access, costs, consents and insurance alongside the remaining flood exposure.
THE QUESTION TO TAKE AWAY
If water came through this section tomorrow, what would it reach first, and could people still get out?
Knowing the answer for the garage, the living floor and the road gives a buyer a much better basis for a decision than the colour of the section on a map.
Need the numbers for a specific property?
Cook Costello’s engineers and surveyors can compare floor, threshold and access levels with available flood information, identify the uncertainties that matter and advise whether further survey or modelling would help.
Send us the address, the LIM if available, and your due diligence deadline. We can advise what the existing records can resolve and agree a scope and timeframe for any further work.



